Omron NT31 Operation Manuals page 364

Touch Switches
Reference
S Window moving key function
This function moves a window by pressing a window moving key, which is pre-
registered on a window, while the NT31/NT31C is running.
Window moving key can be registered on a window screen.
- Window can be moved also by the operation of window control area. (Refer to
page 493)
- Window moving key can be used only on a local window. It does not function if
the window screen is displayed as a global window.
Window moving key has no special attributes.
- Moving a window by the operation of a window moving key
To move a window by the operation of a window moving key, follow the proce-
dure below.
(1) Pre-register a window moving key on the window to be moved.
(2) Press the window movineg key on a window to be moved while the
NT31/NT31C is running.
The window is changed to the frame display only as follows, with the
mark at the center of it.
Window moving key
move
(3) Prss the touch panel of the NT31/NT31C at the moving destination.
Window is moved so that the center position of the window comes to the
pressed position.
This time, "Display Position" of hte corresponding window area is changed.
Press the moving destination
When the window is in a moving status (while
of the window), the following points differ from the normal running status.
- The elements which use the touch panel as an input do not function regard-
less of the screens (base/window) they are registered on. Only the specifi-
cation of the window moving destination is possible.
- Switching to the system menu is not possible.
- Screen switching or window controlling due to the change in bit memory
table, PT status control area or window control area is not possible.
- Screen saver function does not work.
move
markis displayed at the center
Section 7-7
353