A2: User Parameters - YASKAWA T1000A Technical Manual

Table 5.3 Check to see if A1-02 is locked (continuing from step 10 above)
1.
Press to display A1-02.
2.
Press to display the value set to A1-02.
3.
Press and , making sure that the setting values cannot be changed.
4.
Press to return to the first display.
Table 5.4 Enter the Password to Unlock Parameters (continuing from step 4 above)
1.
Press to enter the parameter setup display.
2.
Press to select the flashing digits as shown.
3.
Press to scroll to A1-04.
4. Enter the password "1234".
5.
Press to save the new password.
6. Drive returns to the parameter display.
7.
Press and scroll to A1-02.
8.
Press to display the value set to A1-02. If the first "0" blinks, parameter settings are unlocked.
9.
Use and to change the value if desired (though changing the control mode at this point is not typically done).
10.
Press to save the setting, or press
11. The display automatically returns to the parameter display.
Note: Parameter settings can be edited after entering the correct password. Performing a 2-wire or 3-wire initialization resets the
password to "0000". Reenter the password to parameter A1-05 after drive initialization.
u A2: User Parameters
n
A2-01 to A2-32: User Parameters 1 to 32
The user can select 32 parameters and assign them to A2-01 through A2-32. This saves time later scrolling through the
parameter menu. The list of User Parameters can also track the most recently edited settings and save those parameters to
this list.
No.
A2-01 to A2-32
Saving User Parameters
To save specific parameters to A2-01 to A2-32, first set the access level to allow access to all parameters (A1-02 = 2).
Next assign the parameter number to the User Parameters list by entering it into one of the A2-
is then set to 1, the access level can be restricted so that users can only set and refer to the specific parameters saved as
User Parameters.
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
Step
Step
to return to the previous display without saving changes.
Parameter Name
User Parameters 1 to 32
5.1 A: Initialization
Display/Result
"02" flashes
Display/Result
"01" flashes
OLV
Setting Range Default
A1-00 to o4-13
parameters. If A1-01
5
–
109