A2 User Parameters - YASKAWA CIMR-ZU A Series Programming Manual

1 1 A Initiali ation
7.
Press and scroll to A1-02.
8.
Press to display the value set to A1-02. If the first "0" blinks, parameter settings are unlocked.
Use and to change the value if desired (though changing the control mode at this point is
9.
not typically done).
10.
Press to save the setting, or press
The display automatically returns to the parameter display.
11.
1. Parameter settings can be edited after entering the correct password.
Note:
2. Performing a 2-Wire or 3-Wire initialization resets the password to "0000".
A1 Application Preset
Several Application Presets are available to facilitate drive setup for commonly used applications. Selecting one of these
Application Presets automatically assigns functions to the input and output terminals and sets a predefined group of parameters
to values appropriate for the selected application.
In addition, the parameters most likely to be changed are assigned to the group of User Parameters, A2-01 through A2-16.
User Parameters are part of the Setup Group, which provides quicker access by eliminating the need to scroll through multiple
menus.

A2 User Parameters

A2 1 to A2 2 User Parameters 1 to 2
The user can select up to 32 parameters and assign them to parameters A2-01 through A2-32 to provide quicker access by
eliminating the need to scroll through multiple menus. The User Parameter list can also save the most recently edited
parameters.
No
A2-01 to A2-32
<1> This setting is the default setting of the Setup Mode parameters. Refer to TOEPC71063610 User Manual Section 4 for details.
<2> A1-06 determines how the setting of user parameters A2-01 through A2-32 are changed.
Sa in User Parameters
To save specific parameters to A2-01 through A2-32, set parameter A1-01 to 2 to allow access to all parameters, then enter
the parameter number to one of the A2-
restrict access so users can only set and refer to the parameters saved as User Parameters.
22
Step
to return to the previous display without saving changes.
Parameter Name
User Parameters 1 to 32
parameters to assign it to the list of User Parameters. Finally, set A1-01 to 1 to
Display/ esult
-PRMSET-
Control Method
A1-02= 0
V/f Control
←
-PRMSET-
Control Method
A1-02=
V/f Control
←
-PRMSET-
Control Method
A1-02=
PM OpenLoop Vect
←
Entry Accepted
-PRMSET-
Initialization
A1-00=
Select Language
←
Settin an e
Determined by
A1-00 to S6-07
A1-06
PRG
0
→
FWD
PRG
0
0
→
FWD
PRG
5
0
→
FWD
PRG
0
→
FWD
De ault
<1> <2>