Switching Between Local And Remote - YASKAWA T1000A Technical Manual

n
Setup Group Parameters
Table 4.4 lists parameters available by default in the Setup Group.
If the desired parameter is not listed in the Setup Group, go to the Programming Mode.
Parameter
A1-02 Control Method Selection
b1-01 Frequency Reference Source 1
b1-02 Run Command Source 1
b1-03 Stop Method Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Duty Selection
C6-02 Carrier Frequency Selection
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
d1-04 Frequency Reference 4
d1-17 Jog Frequency Reference
Note: Parameter availability depends on the control mode set in A1-02 that is used to run the drive and motor. Consequently, some of
the parameters listed above may not be accessible in certain control modes.
u Switching Between LOCAL and REMOTE
When the drive is set to accept the Run command from the digital operator RUN key, this is referred to as LOCAL mode.
When the drive is set to accept the Run command from an external device (via the input terminals, serial
communications, etc.) this is referred to as REMOTE mode.
WARNING! Sudden Movement Hazard. The drive may start unexpectedly if the Run command is already applied when switching from
LOCAL mode to REMOTE mode when b1-07 = 1, resulting in death or serious injury. Be sure all personnel are clear of rotating
machinery.
The operation can be switched between LOCAL and REMOTE either by using the LO/RE key on the digital operator or
a digital input.
Note: 1. After selecting LOCAL, the LO/RE light will remain lit.
2. The drive will not allow the user to switch between LOCAL and REMOTE during run.
n
Using the LO/RE Key on the Digital Operator
1. Turn on the power to the drive. The initial display appears.
Press . The LO/RE light will light up. The drive is now in LOCAL.
2.
To set the drive for REMOTE operation, press the
n
Using Input Terminals S1 through S8 to Switch between LO/RE
The user can also switch between LOCAL and REMOTE modes using one of the digital input terminals S1 through S8
(set the corresponding parameter H1-
When setting the multi-function input terminals, setting H1-
Refer to H1 Multi-Function Digital Input Selections on page 388
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
Table 4.4 Setup Group Parameters
Name
Step
key again.
to "1").
4.3 The Drive and Programming Modes
Parameter
E1-01 Input Voltage Reference
E1-03 V/f Pattern Selection
E1-04 Maximum Output Frequency
E1-05 Maximum Voltage
E1-06 Base Frequency
E1-09 Minimum Output Frequency
E1-13 Base Voltage
E2-01 Motor Rated Current
E2-04 Number of Motor Poles
E2-11 Motor Rate Capacity
H4-02 Terminal AM Gain Setting
L1-01 Motor Protection Function Selection
L3-04 Stall Prevention Selection during Deceleration
to 1 disables the LO/RE key on the digital operator.
for a list of digital input selections.
Name
Display/Result
ALM
DIGITAL OPERATOR JVOP-182
DRV
REV DRV FOUT
ALM
DIGITAL OPERATOR JVOP-182
DRV
REV DRV FOUT
LO
ESC
RE
RESET ENTER
RUN STOP
81
4