Simplified Setup Using The Setup Group - YASKAWA T1000A Technical Manual

4.3 The Drive and Programming Modes
The following example is a continuation of the steps above. Here, parameter C1-02 is accessed using the Verify Menu,
and is changed again from 10.0 s to 20.0 s.
To check the list of edited parameters:
1. Turn on the power to the drive. The initial display appears.
2.
Press or
Press to enter the list of parameters that have been edited from their original default settings.
3.
If parameters other than C1-02 have been changed, use the
4.
Press the key to access the setting value. Left digit flashes.
u Simplified Setup Using the Setup Group
In the Setup Group, the drive lists the basic parameters needed to set up the drive for the application. It provides a
simplified way to get the application running right away by showing only the most important parameters.
n
Using the Setup Group
Figure 4.6 illustrates how to enter and how to change parameters in the Setup Group.
In this example, the Setup Group is accessed to change b1-01 from 1 to 0. This changes the source of the frequency
reference from the control circuit terminals to the digital operator.
Figure 4.6
DIGITAL OPERATOR JVOP-182 ALM
DRV
REV DRV FOUT
Frequency reference
Press until
appears when appears
powered up
<1> Use the up and down arrow keys to scroll through the Setup Group. Press the ENTER key to view or change parameter settings.
<2> To return to the previous menu without saving changes, press the ESC key.
80
Step
until the display shows the top of the Verify Menu.
DIGITAL OPERATOR JVOP-182 ALM
REV DRV FOUT
<1>
Figure 4.6 Setup Group Example
or key to scroll until C1-02 appears.
DIGITAL OPERATOR JVOP-182 ALM
REV DRV FOUT
Parameter Display
ALM
DIGITAL OPERATOR JVOP-182
REV DRV FOUT
DIGITAL OPERATOR JVOP-182 ALM
REV DRV FOUT
DIGITAL OPERATOR JVOP-182 ALM
REV DRV FOUT
DIGITAL OPERATOR JVOP-182 ALM
REV DRV FOUT
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
Display/Result
DIGITAL OPERATOR JVOP-182
REV
Control Circuit
Select digit to edit
Terminal
<2>
Operator
<2>
ALM
DRV
DRV FOUT
<2>