Table of Contents
Advertisement
Inside Cuts
Inside cuts can be easily made with your scroll
saw by threading the blade through a hole drilled
in the workpiece. The flex-shaft rotary tool on the
G0735 can be used to assist with drilling.
To make an inside cut:
1.
DISCONNECT MACHINE FROM POWER!
2.
Drill a
⁄
" hole in the workpiece inside the
1
4
waste area of the internal cut.
3.
Remove the blade from the saw.
4.
Insert the blade through the previously drilled
hole in the workpiece (Figure 23).
Note: If using a plain end blade, remove one
blade adapter to allow the blade to be insert-
ed through the workpiece, then re-install the
adapter on the blade.
Figure 23. Example of installing blade for an
inside cut.
5.
Re-install the blade.
6.
Adjust the hold-down shoe and guard, con-
nect the saw to power, then perform the cut.
7.
When finished, disconnect the saw from
power, remove the blade from the saw and
workpiece, remove the workpiece, then re-
install the blade on the saw.
Model G0734/G0735 (Mfd. Since 12/15)
Bevel Cuts
Bevel cuts can be used for miters, cope joints,
and making relief or recessed projects.
To make a bevel cut:
1.
Draw your pattern as described in the previ-
ous sections.
2.
Adjust the table to the desired angle.
3.
Using the same principles as in the previous
sections, feed the work slowly and evenly
into the blade, remembering not to force the
workpiece (see Figure 24).
Figure 24. Example of making a bevel cut.
4.
Wait until all motion has stopped before
removing waste near the blade.
Flex Shaft Tool
To operate the flex-shaft rotary tool:
1.
Position the guard so it covers the hold-down
shoe and touches the table.
2.
Hold the flex-shaft rotary tool, turn the power
ON, and select the desired speed for the
operation using the variable speed dial.
3.
After completing work with the flex-shaft
rotary tool, remove it from the machine and
re-install the flex shaft cap.
-21-
Advertisement
Table of Contents
