Motor Switch - FUTABA 6K Instruction Manual

Motor switch

MOT SW
Function
This function sets the operating motor when
the EP glider with motor is started by switch. The
operating speed can individually set in 2 ranges
of high from slow and slow from high. If you do
motor control with a throttle stick, you should
set this function to INH.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
● Decelerating speed setting
● Accelerating speed setting
Motor
■ Activating the function
① Select the "MODE" item
a n d t h e n s e l e c t t h e
"OFF" by pressing the
+ key or – key.
● When you do not use a function, set to the
"INH" side.
■ Switch direction
③ S e l e c t t h e
＋
" D O W N " it em
and then select
the position by
pressing the + key or – key.
● 2P SW： UP, DOWN
● 3P SW： UP, UP&D, UP&C, CNTR,
C&DN, DOWN
DANGER
Always remove the propeller from the motor during setting and at operation checks.
■There is the danger of the propeller spinning unexpectedly and causing a serious injury.
WING TYPE
② Select
"MOT SW"
from the menu with the
Jog key.
● Present motor
control position
● OFF-position
(0% : OFF)
● ON-position
(100% : High)
■ Switch selection
② Change the switch by
＋ －
or
■ Speed setting
④ Select "SPEED " next to (OFF) and (ON) by Jog key.
－
Range：OFF, 1 ～ 10 (more slowly)
or
(ON)
●
(OFF)
●
1AIL 1AIL1FLP 2AIL
●For safety, the ON/OFF switch of the aircraft itself
can be set.
●If a transmitter power supply is switched on while
the motor SW has been ON, the warning will
operate. Be sure to switch on a power supply with
the motor-start switch OFF.
③ Open the setting screen by
pressing the Jog key.
SAFE SW▶ SwA
▶ DOWN
START SW▶ SwD
▶ DOWN
● Start SW
pressing the + key or
– key a t t h e s w i t c h
selection item.
Range：SwA ～ SwD
is the acceleration speed setting.
is the deceleration speed setting.
(GLIDER)
2AIL1FLP 2AIL2FLP
● If this safety switch
i s n o t O N , t h e
motor will not start
even if the starter
switch is turned on.
In "NULL", a safe
function does not
work.
＋ －
or
139