Encoder Assembly - Pitney Bowes DA80F Service Manual

DA80F (WF81) Parts Removal
5.4 Encoder
Assembly
(continued)
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
5. Loosen set screw by turning the wrench counterclockwise a turn or two
to loosen (do NOT remove the set screw).
6. Unplug ENC harness from encoder.
7. Using a small screwdriver, separate the main body cover of encoder from
encoder mounting backing at the various "pry points" (see figures below).
Pry Points
Pry Points
8. Carefully remove the encoder from its backing plate. Try not to damage
the housing or the backing plate if possible because it is placed by the
factory in a precise position.
• If the encoder was removed intact, skip to step 10.
• If the encoder or backing plate does get damaged, you need to re-
place the backing plate as well as the encoder. You also need to have
on hand the special encoder alignment bushing tool (PN#
Continue with step 9.
Removal and Replacement • 5
ENC Harness
Pry
Points
Backing Plate
).
WS71001
<-Two
Screws
Holding
Backing
Plate
(Circled)
5-7