Da95F (Wf96) Adjustments; Leveling The Print Head Assembly To Deck - Pitney Bowes DA80F Service Manual

DA95F (WF96) Adjustments

6.5 Leveling
the Print Head
Assembly to
Deck (Setting
the Wedge)
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
The print head assembly should be re-levelled in situations where:
• you have replaced it
• you have changed the upper or lower shafts on which it mounts
• you are experiencing printing issues that indicate uneven head position
Levelling the print head assembly involves adjusting the wedge (see below).
1. Lower the adjustable thickness knob to the lowest point.
2. Flip the print head holder assemblies up and out of the way.
3. Place a .010" thick media (for example, 3 sheets of 28 lb. ledger paper)
on top of the belts and below the print head assembly.
4. Lower the print head assembly down on top of the media.
5. Loosen the screw on the print head shaft to let the wedge drop.
Wedge
6. Adjust the screw so that the print head is parallel to the deck (belts).
7. Repeat steps 1- 6 to adjust the other print head assembly.
Adjustments • 6
Print Head
Assemblies
Flipped Up
Completely
Screws
to Adjust
Wedge
(Circled)
6-5