Setting The Print Head Assembly Position - Pitney Bowes AddressRight DA Series Operator's Manual

7. Setting the Print Head Assembly Position

It is necessary to position the print head assembly correctly over
the path of the material so that your images and text will print where
you want them to. The printer can print an area 1.5 in. (38 mm) high
across the width of the material.
A. Loosen the print head assembly clamp knob located on top
of the printer (loosen no more than two full turns). This knob
secures the print head assembly in place.
B. Slide the knob along the slot in the top of the printer to move
the print head assembly. Locate the assembly over the area you
wish to print on the material.
TIP: Place a piece of material along the measuring scale on
the top of the printer and slide the clamp knob up or down
until it is located at the position that you want your image
to print. You can use the red numbers as guides for normal
envelopes, and the blue numbers for inverted envelopes.
Refer to the help system or documentation provided with
your software application for more information on normal and
inverted envelopes.
C. Tighten the knob to secure the assembly in place.
D. Put material in the printer and then press the test envelope
button to print a test address. Check that this is the location
required for printing on the material. Redo the above steps to
make further adjustments to the location, if necessary.
When you're satisfied with your setup adjustments, you are ready to
run the job. The following pages explain how to use the printer with
your computer.
SV61722 Rev. D
Printer Basics • 2
PRINT AREA
2-9