Rear Cover/Side Guides - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Standard Feeder (WF9S) Parts Removal
5.22 Rear
Cover/Side
Guides on
Standard
Feeder
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
1. Lift up the feeder assembly and unhook it from the printer. Pull the feeder
assembly away from the printer.
2. Disconnect the feeder signal cable from the printer.
3. Remove the quick release pin from the feed ramp assembly. Raise the
feed ramp assembly up and remove the support bar completely from the
feed assembly (see figure on bottom right). Remove feed ramp.
4. Push the lever up to raise the separator H-block to the uppermost posi-
tion and secure in place.
5. Pull the side guides (sliding fences) wide open on the feeder assembly.
Optionally, remove the side guides should they hinder the removal of the
feeder deck (two screws per side guide).
Removal and Replacement • 5
Feeder
Signal
Cable
Quick
Release
Pin
Feed
Ramp
Assembly
Side Guides
Lever for
"H" Block
5-39