Front Cover And Keyboard/Lcd Display Board - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Printer Parts Removal
5.29 Front
Cover and
Keyboard/LCD
Display Board
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
WARNING!
Always wear anti static wrist straps (L-8298) whenever handling the LCD
Display Board or Processor Board. Static discharge will damage the IC chips.
1. Turn the power off and unplug the AC power cord.
2. Disengage the feeder assembly from the printer (see section 5.22).
3. Lift printer cover up to full extension.
4. Turn the adjustment knob to loosen the print head brake. Slide the print
head assemblies away from the front cover.
5. From the feeder side of the printer, unfasten the two screws holding the
front cover to the entry roller support frame.
6. From inside the printer on the exit side, unfasten the two screws holding
the front cover to the exit frame, including the green ground strap.
7. Slide the printer to the edge of the table so the front cover completely
overhangs the edge. Unfasten the three screws on the bottom of the front
cover, while hanging onto the cover to keep it from dropping.
IMPORTANT: The figure below is presented to show the location of the
bottom screws only. Do NOT rest the printer on the cover side that has
the hand held because the cover may crack from the weight of the printer.
8. Pull the cover away from the printer.
Removal and Replacement • 5
Two Screws on Exit
Frame Side (obscured
in figure)
Front
Cover
Two Screws on
Feeder Side
Front Cover
Screws for
Front Cover
(circled)
5-49