HEIDENHAIN TNC 640 User Manual page 832

21
Parameter list
Parameter settings
DisplaySettings
Settings for screen display
Sequence of displayed axes
[0] to [7]
Sequence of the displayed axes in the REF display
[0] to [7]
Type of position display in position window
NOMINAL
ACTUAL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M 118
Type of position display in status display
NOMINAL
ACTUAL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M 118
Definition of decimal separator for position display
. point
, comma
Display of feed rate in operating mode Manual operation
at axis key: Only display feed rate if axis direction key is pressed
always minimum: Always display feed rate
Display of spindle position in the position display
during closed loop: Only display spindle position if spindle is in position control
during closed loop and M5: Display spindle position if spindle is in position control
and with M5
Show or hide soft key preset table
True: Soft key preset table is not displayed
832
Depends on available axes
Depends on available axes
Tables and Overviews | Machine-specific user parameters
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017