HEIDENHAIN TNC 640 User Manual page 116

2
Backing up data
To backup data from the control, proceed as follows:
Select NC/PLC Backup
Select the type
Back up the TNC partition
Back up the directory tree: Select the directory for backup in
the file management
Back up the machine configuration (for machine tool builders
only)
Complete backup (for machine tool builders only)
Comment: Freely configurable comment for the backup
Select the next step with the FORWARD soft key
Stop the control if required with the STOP NC SOFTWARE soft
key
Define the exclusion rules
User preset rules
Write own rules to the table
Select the next step with the FORWARD soft key
The control generates a list of files for backing up.
Check the list. Deselect files if necessary.
Select the next step with the FORWARD soft key
Enter the name of the backup file
Select the storage path
Select the next step with the FORWARD soft key
The control generates the backup file.
Confirm with the OK soft key
The control concludes the backup process and restarts the NC
software.
116
Introduction | Window manager
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017