HEIDENHAIN TNC 640 User Manual page 811

Hide thumbs Also See for TNC 640:

Table of Contents

MOD Functions | Setting up data interfaces

Data transfer between the control and TNCremo

Check whether the control is connected to the correct serial port

on your PC or to the network.

Once you have started TNCremo, you will see a list of all files that

are stored in the active directory in the upper section of the main

window 1. Using <File>, <Change directory>, you can select any

drive or another directory on your PC.

If you want to control data transfer from the PC, establish the

connection with your PC in the following manner:

Select <File>, <Setup connection>. TNCremo now receives the

file and directory structure from the control and displays this in

the lower part of the main window

To transfer a file from the control to the PC, select the file in the

control window per mouse click and move the highlighted file

into the PC window while holding down the mouse button

To transfer a file from the PC to the control, select the file in the

PC window per mouse click and move the highlighted file into

the control window while holding down the mouse button

If you want to control data transfer from the control, establish the

connection with your PC in the following manner:

Select <Extras>, <TNCserver>. TNCremo then starts in server

mode and can receive data from the control or send data to the

You can now call the file management functions on the control

by pressing the PGM MGT key in order to transfer the desired

Further information:

carrier", page 197

If you have exported a tool table from the control, then

the tool types are converted to tool type numbers.

Further information:

Select <File>, <Exit>

You can open the context-sensitive help function of the

TNCremo software by pressing the F1 key.

HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017

"Data transfer to or from an external data

"Available tool types", page 272