HEIDENHAIN TNC 640 User Manual page 32

Modified functions 34059x-08
If you use locked tools, the control displays a warning in
the Programming and Test Run operating modes, see
"Programming graphics", page 216, see "Test run",
page 767
The M94 miscellaneous function is effective for all rotary axes
that are not limited by software limit switches or traverse limits,
see "Reducing display of a rotary axis to a value less than 360°:
M94", page 584
The control offers a positioning logic for returning to the contour,
see "Returning to the contour", page 787
The positioning logic for returning to the contour with a
replacement tool has changed, see "Tool change", page 256
Axes that are not active in the current kinematic model can
also be referenced in a tilted working plane, see "Crossing the
reference point in a tilted working plane", page 667
Holes and threads are shown in light blue in the programming
graphics, see "Programming graphics", page 216
The tool is shown in red in the graphics while it is in contact
with the workpiece, and blue during air cuts, see "Tool display",
page 762
The positions of the sectional planes are no longer reset when
a program or a new blank form is selected, see "Projection in
three planes", page 760
Spindle speeds can be entered with decimal places also in
the Manual operation mode. The control displays the decimal
places when the spindle speed is < 1000, see "Entering values",
page 682
The sort order and the column widths in the tool selection
window are retained when the control is switched off, see
"Calling the tool data", page 254
If a subprogram called with %:PGM ends with M2 or M30,
the control issues a warning. The control automatically clears
the warning as soon as you select another NC program, see
"Programming notes", page 356
The control displays an error message in the header until it is
cleared or replaced by a higher-priority error, see "Display of
errors", page 220
The time needed to paste a large amount of data into an
NC program was considerably reduced.
To connect a USB stick you no longer have to press a soft
key, see "Connecting and removing USB storage devices",
page 186
The speed of setting the jog increment, spindle speed and feed
rate was adjusted for electronic handwheels.
The icons of basic rotation, 3-D basic rotation and tilted working
plane were modified to make them easier to distinguish, see
"General status display", page 94
The icon for FUNCTION TCPM was modified, see "General
status display", page 94
The icon for the AFC function was modified, see "General status
display", page 94
32
Fundamentals | Control model, software and features
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017