HEIDENHAIN TNC 640 User Manual page 820

20
Option
Method
Log
Computer
Advanced options
Set standard
values
820
Meaning
Under Method you can configure whether
the service should not be available to
anyone (Prohibit all), available to everyone
(Permit all) or only available to some (Permit
some). If you set Permit some you must
also specify the computer (under Comput-
er) that you wish to grant access to the
respective service. If you do not specify
any computer under Computer, the setting
Prohibit all will automatically become active
when the configuration is saved.
If Log is activated, a red message is output
if a network packet for this service has been
blocked. A (blue) message is output if a
network packet for this service was accept-
ed
If the setting Permit some is selected
under Method, the relevant computers can
be specified here. The computers can be
entered with their IP addresses or host
names separated by commas. If a host
name is used, the system checks upon
closing or saving of the dialog whether
the host name can be translated into an
IP address. If this is not the case, an error
message is displayed and the dialog does
not terminate. If a valid host name is speci-
fied, this host name is translated into an
IP address each time the control is start-
ed. If a computer that was entered with its
name changes its IP address, you may have
to restart the control or formally change
the firewall configuration to ensure that the
control uses the new IP address for a host
name in the firewall.
These settings are only intended for your
network specialists
Resets the settings to the default values
recommended by HEIDENHAIN
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017
MOD Functions | Firewall