HEIDENHAIN TNC 640 User Manual page 416

10
Group Gruppen-
name nummerID
Measure the maximum utilization of an axis
621
Read SIK contents
630
Write data for unbalance monitoring
850
Workpiece counter
920
Read and write data of current tool
950
416
Systemdaten- Index
nummer
0 Index of physi-
cal axis
0 Option no.
1 -
2 -
10 -
10 -
1 -
2 -
12 -
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
Programming Q Parameters | Additional functions
Description
Conclude measurement of the dynamic
load and save the result in the specified Q
parameter.
You can explicitly determine whether the SIK
option given under IDX has been set or not.
1 = option is enabled
0 = option is not enabled
You can determine whether a Feature
Content Level (for upgrade functions) is set,
and which one.
–1 = No FCL is set
<No.> = FCL that is set
Read serial number of the SIK
-1 = No valid SIK in the system
Define the type of control:
0 = iTNC 530
1 = NCK-based control (TNC 640, TNC 620,
TNC 320, TNC 128, PNC 610, ...)
Activate and deactivate unbalance monitoring
0 = unbalance monitoring not active
1 = unbalance monitoring active
Planned workpieces.
In Test Run operating mode the counter
generally generates the value 0.
Already machined workpieces.
In Test Run operating mode the counter
generally generates the value 0.
Workpieces still to be machined.
In Test Run operating mode the counter
generally generates the value 0.
Tool length L
Tool radius R
Tool radius R2
Oversize for tool length DL
Tool radius oversize DR
Tool radius oversize DR2
Tool locked TL
0 = not locked, 1 = locked
Number of the replacement tool RT
Maximum tool age TIME1
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017