HEIDENHAIN TNC 640 User Manual page 275

Tools | Tool management (option number 93)
The CSV file to be imported must be stored in the
TNC:\system\tooltab directory.
If you import the tool data of existing tools (whose
numbers are in the pocket table) the control issues
an error message. You can then decide whether to
skip this data record or insert a new tool. The control
inserts a new tool into the first empty line of the tool
table.
If the imported CSV file contains unknown table
columns, the control displays a message during
import. An additional note informs you that the data
will not be transferred.
Make sure that the column designations have been
specified correctly.
Further information:
table", page 238
You can import any tool data, the associated data
record does not have to contain all the columns (or
data) of the tool table.
The column names can be in any order, the data
must be defined in the corresponding order.
Example
T,L,R,DL,DR
4,125.995,7.995,0,0
9,25.06,12.01,0,0
28,196.981,35,0,0
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017
"Entering tool data into the
Line 1 with column names
Line 2 with tool data
Line 3 with tool data
Line 4 with tool data
6
275