HEIDENHAIN TNC 640 User Manual page 494

12
Parameterizing the tool carrier template in the Manual
operation operating mode
Proceed as follows to parameterize tool carrier templates and
save these parameters:
Press the Manual operation key
Press the TOOL TABLE soft key
Press the EDIT soft key
Move the cursor to the KINEMATIC column
Press the SELECT soft key
Press the TOOL HOLDER WIZARD soft key
The control opens the additional
ToolHolderWizard tool in a pop-up window.
Press the OPEN FILE icon
The control opens a pop-up window.
Select the desired tool carrier template using the
preview screen
Press the OK button
The control opens the selected tool carrier
template.
The cursor goes to the first parameterizable
value.
Adjust values
Enter the name for the parameterized tool holder
in the Output file area
Press the GENERATE FILE button
If required, reply to the message on the control
Press the CLOSE icon
The control closes the additional tool
494
Special Functions | Tool carrier management
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017