Setting Fence Stops - Grizzly G0958 Owner's Manual

Setting Fence Stops

The fence on the Model G0958/G0959 has
adjustable stops at the 90º and 45º outward (135º)
positions for quickly and accurately setting the
desired fence angle.
Note: To ensure accurate results when jointing,
check the accuracy of these settings frequently
(every month at a minimum).
Tools Needed
Hex Wrenches 2.5, 4, 5mm .........................1 Ea.
Open-End Wrench 7, 8, 10mm ....................1 Ea.
Combination Square .......................................... 1
Phillips Head Screwdriver #2 ............................ 1
Setting 90º Fence Stop
1.
DISCONNECT MACHINE FROM POWER!
2. Loosen fence tilt lock handle (see Figures
49–50) and adjust fence to 90º position (0º on
fence scale), then tighten handle.
G0958
Jam Nut
90º Fence
Cap Screw Stop
Figure 49. Components for setting 90º fence
angle (G0958).
Model G0958/G0959 (Mfd. Since 05/22)
G0959
90º Fence
Stop
Screw
Qty
Figure 50. Components for setting 90º fence
3. Place combination square on jointer table
with 90º side against fence (see Figure 51).
— If fence is flush against combination
— If fence is not flush against combination
Tilt Lock
Handle
Figure 51. Example of checking 90º fence angle
4.
Loosen jam nut and cap screw shown in
Figures 49–50.
5.
Loosen fence tilt lock handle, adjust fence
until it is flush against combination square,
then tighten handle.
6. Adjust cap screw until it just touches 90º
fence stop, then tighten jam nut without let-
ting cap screw move.
Cap
angle (G0959).
square, 90º fence stop is set correctly. No
adjustment is necessary.
square, proceed to Step 4.
with square.
Tilt Lock
Handle
Jam
Nut
-49-