Test Run - Grizzly T33959 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, 2) the
chuck guard safety switch disables the machine
properly, and 3) the Emergency Stop button dis-
ables the machine properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
Clear all setup tools away from machine.
1.
Press Emergency Stop button (see Figure 28).
2.
-24-
Figure 28. Location of power controls (T33959
shown).
Connect machine to power supply.
3.
Note: Spindle speed digital readout will not
illuminate until Step 4 is completed.
Twist Emergency Stop button clockwise until
4.
it springs out (see Figure 29). This resets
switch so machine can start.
Emergency Stop Button
Figure 29. Resetting Emergency Stop button.
Press green ON button (I) to start spindle
5.
rotation (see Figure 28). Verify motor starts
up and runs smoothly without any unusual
problems or noises.
Model T33959/60/61 (Mfd. Since 08/23)
Emergency
Stop Button
ON Button