Dell PowerConnect J-EX4200-24T Software Manual page 1610

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Options
Required Privilege
Level
1538
any —Configure the family type to be both unicast and multicast.
—Configure NLRI parameters for IPv4.
inet
—Configure NLRI parameters for IPv6.
inet6
—Configure NLRI parameters for the multicast distribution tree (MDT) subaddress
inet-mdt
family identifier (SAFI) for IPv4 traffic in Layer 3 VPNs.
inet-mvpn —Configure NLRI parameters for IPv4 for multicast VPNs.
—Configure NLRI parameters for IPv6 for multicast VPNs.
inet6-mvpn
—Configure NLRI parameters for IPv4 for Layer 3 VPNs.
inet-vpn
inet6-vpn —Configure NLRI parameters for IPv6 for Layer 3 VPNs.
—Configure NLRI parameters for IS-IS for Layer 3 VPNs.
iso-vpn
—Configure NLRI parameters for IPv4 for MPLS-based Layer 2 VPNs and VPLS.
l2-vpn
labeled-unicast —Configure the family type to be labeled-unicast. This means that the
BGP peers are being used only to carry the unicast routes that are being used by
labeled-unicast for resolving the labeled-unicast routes. This statement is supported
only with inet and inet6
—(Optional) Specify the maximum number of times that the AS number
loops number
can appear in the AS path received from a BGP peer for the specified address family.
For , include a value from 1 through 10.
number
NOTE: When you configure the
family, that value is used to evaluate the AS path for routes received by a
BGP peer for the specified address family rather than the loops value
configured for the global AS number.
multicast —Configure the family type to be multicast. This means that the BGP peers are
being used only to carry the unicast routes that are being used by multicast for
resolving the multicast routes.
—Configure the family type to be unicast. This means that the BGP peers only
unicast
carry the unicast routes that are being used for unicast forwarding purposes.
Default:
unicast
The remaining statements are explained separately.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
.
loops statement for a specific BGP address