Configuring Multiple Vlan Registration Protocol (Mvrp) (Cli Procedure) - Dell PowerConnect J-EX4200-24T Software Manual

Table 152: RTG Configuration Fields (continued)
Field
Member Interface 2
Select Primary Interface
Dynamically select my active
interface
Related
Documentation

Configuring Multiple VLAN Registration Protocol (MVRP) (CLI Procedure)

Enabling MVRP
Disabling MVRP
Function
Specifies a trunk interface containing multiple VLANs.
Enables you to specify one of the interfaces in the RTG
as the primary link. The interface without this option is
the secondary link in the RTG.
Specifies that the system dynamically selects the
active interface.
Example: Configuring Redundant Trunk Links for Faster Recovery on page 1101
Understanding Redundant Trunk Links on J-EX Series Switches on page 1049
Multiple VLAN Registration Protocol (MVRP) is used to manage dynamic VLAN registration
in a LAN. You can use MVRP on J-EX Series switches.
MVRP is disabled by default on J-EX Series switches.
To enable MVRP or set MVRP options, follow these instructions:
Enabling MVRP on page 1147
Disabling MVRP on page 1147
Disabling Dynamic VLANs on page 1148
Configuring Timer Values on page 1148
Configuring MVRP Registration Mode on page 1149
MVRP can only be enabled on trunk interfaces.
To enable MVRP on all trunk interfaces on the switch:
[edit protocols mvrp]
user@switch# set interface all
To enable MVRP on a specific trunk interface:
[edit protocols mvrp]
user@switch# set interface xe-0/0/1.0
MVRP is disabled by default. You only need to perform this procedure if you have
previously enabled MVRP.
To disable MVRP on all trunk interfaces on the switch:
Chapter 59: Configuring Bridging and VLANs
Your Action
Select a trunk interface from the list.
1. Select the option button.
2. Select the primary interface.
Select the option button.
1147