Dell PowerConnect J-EX4200-24T Software Manual page 2020

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 246: show route extensive Output Fields (continued)
Field Name Field Description
Route Distinguisher IP subnet augmented with a 64-bit prefix.
Next-hop type Type of next hop. For a description of possible values for this field, see the Output Field table in the
show route detail command.
Number of references made to the next hop.
Next-hop reference
count
Source IP address of the route source.
Next hop Network layer address of the directly reachable neighboring system.
Interface used to reach the next hop. If there is more than one interface available to the next hop, the
via
name of the interface that is actually used is followed by the word
the following information:
Name of the label-switched path (LSP) used to reach the next hop.
Label-switched-path
lsp-path-name
MPLS label and operation occurring at this routing device. The operation can be
Label operation
is removed from the top of the stack),
(where a label is replaced by another label).
Whether the metric has been increased or decreased by an offset value.
Offset
(Local only) Local interface name.
Interface
Protocol next hop Network layer address of the remote routing device that advertised the prefix. This address is used
to recursively derive a forwarding next hop.
label-operation MPLS label and operation occurring at this routing device. The operation can be
is removed from the top of the stack),
(where a label is replaced by another label).
When present, a list of nodes that are used to resolve the path to the next-hop destination, in the
Indirect next hops
order that they are resolved.
State of the route (a route can be in more than one state). See the Output Field table in the show
State
route detail command.
1948
Weight—Value used to distinguish primary, secondary, and fast reroute backup routes. Weight
information is available when Multiprotocol Label Switching (MPLS) label-switched path (LSP)
link protection, node-link protection, or fast reroute is enabled, or when the standby state is enabled
for secondary paths. A lower weight value is preferred. Among routes with the same weight value,
load balancing is possible.
Balance—Balance coefficient indicating how traffic of unequal cost is distributed among next hops
when a routing device is performing unequal-cost load balancing. This information is available
when you enable Border Gateway Protocol (BGP) multipath load balancing.
Selected
(where another label is added to the label stack), or
push
(where another label is added to the label stack), or
push
. This field can also contain
(where a label
pop
swap
pop (where a label
swap