Dell PowerConnect J-EX4200-24T Software Manual page 1887

Table 215: show bgp neighbor Output Fields (continued)
Field Name Field Description
Options Configured BGP options:
Name of the authentication key chain enabled.
Authentication key
change
Authentication Type of authentication algorithm enabled:
algorithm
Names of configured address families for the VPN.
Address families
configured
Local Address Address of the local routing device.
Hold time configured with the
Holdtime
keepalive messages are sent.
Flags related to labeled-unicast:
Flags for NLRI
inet-label-unicast
Traffic statistics Information about labeled-unicast traffic statistics:
Time between sample periods for labeled-unicast traffic statistics, in seconds.
Traffic Statistics
Interval
Preference value configured with the
Preference
Number of times the BGP session has gone down and then come back up.
Number of flaps
Router identifier of the peer.
Peer ID
—Configured address family:
AddressFamily
—Authentication key change is enabled.
AutheKeyChain
GracefulRestart —Graceful restart is configured.
—Hold time configured with the
HoldTime
interval at which keepalive messages are sent.
—Address configured with the
Local Address
—Allow BGP connections to external peers that are not on a directly connected network.
Multihop
NLRI —Configured MBGP state for the BGP group:
.
nlri any
—Configured peer autonomous system (AS).
Peer AS
Preference —Preference value configured with the
—Configured to refresh automatically when the policy changes.
Refresh
—Configured routing table group.
Rib-group
hold-time
—Collection of statistics for labeled-unicast traffic is enabled.
TrafficStatistics
—Options configured for collecting statistics about labeled-unicast traffic.
Options
—Name and location of statistics log files.
File
—Size of all the log files, in bytes.
size
—Number of log files.
files
Chapter 74: Operational Commands for Layer 3 Protocols
or .
inet inet-vpn
statement. The hold time is three times the
hold-time
statement.
local-address
multicast , unicast
preference statement.
hmac or md5
statement. The hold time is three times the interval at which
statement.
preference
, or both if you have configured
1815