Dell PowerConnect J-EX4200-24T Software Manual page 1855

Output Fields
Table 206: show (ospf | ospf3) neighbor Output Fields
Field Name Field Description
Address Address of the neighbor.
Interface Interface through which the neighbor is reachable.
State State of the neighbor:
Attempt
indicates that no recent information has been received from the neighbor,
but that a more concerted effort must be made to contact the neighbor.
Down
information has been received from the neighbor. Hello packets might
continue to be sent to neighbors in the
frequency.
Exchange
sending database description packets to the neighbor. Each packet has a
sequence number and is explicitly acknowledged.
ExStart
routing devices. The goal of this step is to determine which routing device is
the master, and to determine the initial sequence number.
Full
in router link and network link advertisements.
Init
bidirectional communication has not yet been established with the neighbor.
This state may occur, for example, because the routing device itself did not
appear in the neighbor's hello packet.
Loading
recent advertisements that have been discovered (but not yet received) in
the
2Way
state has been ensured by the operation of the Hello Protocol. This is the
most advanced state short of beginning adjacency establishment. The
(backup) designated router is selected from the set of neighbors in state
2Way
Router ID of the neighbor.
ID
Priority of the neighbor to become the designated router.
Pri
Dead Number of seconds until the neighbor becomes unreachable.
show ospf neighbor detail on page 1784
show ospf neighbor extensive on page 1785
show ospf3 neighbor detail on page 1786
show ospf neighbor area area-id on page 1786
show ospf neighbor interface interface-name on page 1786
show ospf3 neighbor instance all (OSPFv3 Multiple Family Address Support
Enabled) on page 1786
Table 206 on page 1783 lists the output fields for the
Output fields are listed in the approximate order in which they appear.
—Valid only for neighbors attached to nonbroadcast networks. It
—Initial state of a neighbor conversation. It indicates that no recent
—Routing device is describing its entire link-state database by
—First step in creating an adjacency between the two neighboring
—Neighboring routing devices are fully adjacent. These adjacencies appear
—A Hello packet has recently been sent by the neighbor. However,
—Link-state request packets are sent to the neighbor to acquire more
Exchange state.
—Communication between the two routing devices is bidirectional. This
or greater.
Chapter 74: Operational Commands for Layer 3 Protocols
show (ospf | ospf3) neighbor
state, although at a reduced
Down
command.
Level of Output
All levels
All levels
All levels
All levels
All levels
All levels
1783