Dell PowerConnect J-EX4200-24T Software Manual page 1972

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 239: show route Output Fields (continued)
Field Name Field Description
destination-prefix Route destination (for example:
format, such as:
Protocol from which the route was learned and the preference value for the route.
[ protocol, preference ]
In every routing metric except for the BGP
use common comparison routines, Junos OS stores the 1's complement of the
Preference2
If the
has a higher
weeks:days How long the route been known (for example,
and 14 seconds).
hours:minutes:seconds
Cost value of the indicated route. For routes within an AS, the cost is determined by IGP and the
metric
individual protocol metrics. For external routes, destinations, or routing domains, the cost is determined
by a preference value.
Local preference value included in the route.
localpref
Interface from which the route was received.
from
1900
(for example,
MPLS-label 80001
interface-name (for example,
neighbor-address:control-word-status:encapsulation type:vc-id :source
10.1.1.195:NoCtrlWord:1:1:Local/96
—Address of the neighbor.
neighbor-address
—Whether the use of the control word has been negotiated for this virtual
control-word-status
circuit: or
NoCtrlWord CtrlWord
encapsulation type —Type of encapsulation, represented by a number: (1) Frame Relay DLCI, (2)
ATM AAL5 VCC transport, (3) ATM transparent cell transport, (4) Ethernet, (5) VLAN Ethernet,
(6) HDLC, (7) PPP, (8) ATM VCC cell transport, (10) ATM VPC cell transport.
vc-id —Virtual circuit identifier.
—Source of the advertisement:
source
—A plus sign indicates the active route, which is the route installed from the routing table into the
+
forwarding table.
—A hyphen indicates the last active route.
-
* —An asterisk indicates that the route is both the active and the last active route. An asterisk before
a line indicates the best subpath to the route.
to
field. For example, if the
value for Route 2 is 155, the
LocalPref
value and a lower
LocalPref
10.0.0.1/24) . Sometimes the route information is presented in another
).
ge-1/0/2 ).
):
.
or .
Local Remote
attribute, a lesser value is preferred. In order to
LocalPref
value for Route 1 is 100, the
LocalPref
value is -156. Route 2 is preferred because it
Preference2
value.
Preference2
2w4d 13:11:14 , or 2 weeks, 4 days, 13 hours, 11 minutes
(Layer 2 circuit only; for example,
value in the
LocalPref
value is -101.
Preference2