Dell PowerConnect J-EX4200-24T Software Manual page 1571

authentication loose-check
detection-time threshold milliseconds
full-neighbors-only
minimum-interval milliseconds
Range: 1 through 255,000 milliseconds
minimum-receive-interval milliseconds
Range: 1 through 255,000 milliseconds
multiplier number
Range: 1 through 255
Default: 3
no-adaptation
transmit-interval threshold milliseconds
Range: 0 through 4,294,967,295 (2
transmit-interval minimum-interval milliseconds
Range: 1 through 255,000
version
Range:
Default:
The remaining statements are explained separately.
Required Privilege routing—To view this statement in the configuration.
Level routing-control—To add this statement to the configuration.
—(Optional) Configure loose authentication checking on the
BFD session. Use only for transitional periods when authentication may not be
configured at both ends of the BFD session.
detection time adapts to a value equal to or greater than the threshold, a single trap
and a single system log message are sent.
—Establish BFD sessions only for OSPF neighbors in the full state. The
default behavior is to establish BFD sessions for all OSPF neighbors.
routing device transmits a hello packet and then expects to receive a reply from the
neighbor with which it has established a BFD session.
the routing device expects to receive a reply from a neighbor with which it has
established a BFD session.
—Configure the number of hello packets not received by a neighbor
that causes the originating interface to be declared down.
—Specify that BFD sessions should not adapt to changing network
conditions. We recommend that you not disable BFD adaptation unless it is preferable
not to have BFD adaptation enabled in your network.
transmit interval adapts to a value greater than the threshold, a single trap and a
single system log message are sent. The interval threshold must be greater than the
minimum transmit interval.
the routing device transmits hello packets to a neighbor with which it has established
a BFD session.
—Specify the BFD version to detect.
(BFD version 1) or
1 automatic
automatic
Chapter 73: Configuration Statements for Layer 3 Protocols
—Configure a threshold. When the BFD session
—Configure the minimum intervals at which the local
—Configure only the minimum interval at which
—Configure a threshold. When the BFD session
32
– 1)
—Configure the minimum interval at which
(autodetect version)
1499