A-1-5 Ethercat Master Setting Procedure; Ethercat Master Setting Procedure - Omron CJ1W-ECT21 Operation Manual

Appendices
11
Check the I/O Communications Area Reference Table values in the Edit Special Unit Settings
Tab Page.
Click the Compare Button. If the compare is successful, click the Transfer from Controller
Button to update the I/O Communications Area Reference Table values. If the compare is
unsuccessful, transfer the settings again. Refer to the Sysmac Studio Version 1 Operation Man-
ual (Cat. No. W504) for the comparison and transfer of the Special Unit setting procedure.
A-1-5

EtherCAT Master Setting Procedure

The setting procedure of the EtherCAT master is provided below. Refer to the Sysmac Studio Version 1
Operating Manual (Cat. No. W504) for Sysmac Studio operating procedures.
The ESI files for OMRON EtherCAT slaves are already installed in the Sysmac Studio. Update the Sys-
mac Studio to get the ESI files for the most recent EtherCAT Slave Unit.
1
Create a project in the Sysmac Studio.
2
Create the EtherCAT network configuration offline.
A - 8
CJ-series EtherCAT Slave Units Operation Manual for NJ-series CPU Unit (W542)