Omron CJ1W-ECT21 Operation Manual page 148

Appendices
5
Set the I/O Communication Area Setting Table on the Edit Special Unit Settings Tab Page.
An example is shown below.
6
With the power OFF, set the unit number and node address with the corresponding hardware
switches. Refer to 2-1-3 Switch Settings on page 2-5.
7
Mount the EtherCAT Slave Unit to the NJ-series CPU Rack. Refer to 2-2-2 Mounting on page
2-7.
8
Connect the communications cable between the EtherCAT master and EtherCAT Slave Unit.
Refer to 2-3 EtherCAT Network Wiring on page 2-9.
9
Turn ON the power supply to the NJ-series Controller.
A - 6
CJ-series EtherCAT Slave Units Operation Manual for NJ-series CPU Unit (W542)