Connect Pin Pad Or Smart Card Reader - VeriFone Omni 5 series Installation Manual

T S
ERMINAL ETUP
Connect Optional Device(s)
CAUTION
NOTE
Connect PIN Pad
or Smart Card
Reader
20
O 5 I
MNI XXX NSTALLATION
Use the two ports on the back panel to connect up to two optional devices.
Before connecting any peripheral device, remove the power cord from the bottom
of the terminal and ensure that the green indicator LED is not lit. Reconnect the
power cord only after you are finished connecting the peripheral device(s). For
complete information about peripheral installation and use, refer to the user
documentation supplied with those devices.
The following sections discuss the most common optional devices supported by
this terminal.
Table 3 Optional Devices Supported
Optional Device
CR 600 or CR1000i (check readers)
Console
PIN pad
RS-232 Electronic Cash Register
Smart Card Reader
Other optional devices may be supported. For more information, please contact
your VeriFone distributor.
RS-232-type devices do not work on the PIN pad port; PIN pad-type devices do
not work on the RS-232 port. If an optional peripheral device does not function
correctly, check the port connection.
Use the following procedure to connect a PIN pad or smart card reader.
1
Insert the RJ45-type connector on the end of the PIN pad or smart card reader
into the port on back of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
If a cable is not already connected to the smart card reader or PIN pad, insert
the small modular plug on one end of the interface cable into the optional
device's modular jack.
2
Insert the larger RJ45-type connector on the other end of the PIN pad cable
into the PIN pad serial port on the bottom of the terminal.
G
UIDE
Connection Port
RS232
PIN pad
PIN pad
RS232
PIN pad