VeriFone Omni 5 series Installation Manual page 25

NOTE
Smart Battery Life
WARNING
Install/Replace
SIM Card (GSM
models)
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery and none of the indicator LEDs (see
pack blink. The battery must then be recharged to restore operation.
The Omni 5xxx terminal automatically shuts off when the smart battery reaches
the critically low charge state. If this occurs, the smart battery must recharge a
minimum of 1/2 hour before it can power the terminal. It make take several
recharge attempts to reset the safety circuit when charging a smart battery that
has reached a critically low charge state.
If the Omni 5xxx terminal is already running an application (for example, SoftPay),
a battery status indicator may appear on the display.
Figure 16 Smart Battery Charge Indicator LEDs and Test Button
To ensure that you get the longest possible performance from the smart battery, it
must be allowed to fully discharge periodically. The smart battery can be charged
and discharged hundreds of times, but will eventually wear out. When operating
times are noticeably shorter than usual, it is time to buy a new battery (see
Accessories and Documentation
Do not dispose of batteries in a fire. Li-ion batteries must be recycled
or disposed of properly. Do not dispose of Li-ion batteries in municipal
waste sites.
The SIM (Subscriber Identity Module) card is a smart card inserted in the Omni
5xxx GSM terminal that contains your GSM radio account information. Use the
following procedure to replace or install a SIM card.
1
Remove screw from SIM card access door on back of Omni 5xxx terminal
(Figure 17).
Figure 17 Remove SIM Door Screw
Install/Replace SIM Card (GSM models)
Figure
BATTERY CHARGE STATE
TEST BUTTON AND STATUS
INDICATOR LEDS
for ordering information).
O
MNI
T S
ERMINAL ETUP
16) on the battery
5 I G
XXX NSTALLATION UIDE
25