Monitoring And Controlling Ups Operation; Figure 6. Location Of The Monitor Panel And The Control Panel - Powerware 9315 Operation Manual

Monitoring and Controlling UPS Operation

After you start the UPS, no operator intervention is necessary except for periodic
checks of the UPS status. Manual operation is required only during routine
maintenance or service. Use the Monitor Panel and the Control Panel to monitor
and control the UPS. Figure 6 shows the location of these two panels on the front
of the UPS.
MONITOR
PANEL

Figure 6. Location of the Monitor Panel and the Control Panel

The Monitor Panel on the left front of the UPS continually indicates the present
mode of UPS operation. This panel contains an LCD screen, backlit status
indicators, and the LOAD OFF pushbutton. Use the LCD screen on the Monitor
Panel to view performance meters or graphic representations of UPS operation.
The Monitor Panel is described in detail in Chapter 5, "Using the Monitor Panel."
A quick reference label describing how to use the Monitor Panel is located inside
the UPS above the Control Panel.
Open the right front door of the UPS to view the Control Panel containing various
controls and switches. These control power to and from the UPS, and allow you
to change the UPS mode manually. The Control Panel is discussed in Chapter 4.
Powerware 9315 (200 kVA ---300 kVA) Operation
164201036 Rev. D 041500
CONTROL PANEL
13