Figure 16. Time Setup Screen - Powerware 9315 Operation Manual

Select Time from the Setup menu to display the Time Setup screen. The Time
Setup screen allows you to set the internal timestamp of the UPS. The timestamp
is used for logging events in the Event History Log. Figure 16 shows the Time
Setup screen.
UPS System Normal
Alarm: None
Notice: None
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters Events
The small return arrow (
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the timestamp settings. To change a setting in the timestamp, press the
and pushbuttons to highlight the setting you want to change. To increase the
setting (make it a higher value), press the
(make it a lower value), press the
upon exit from this screen, be sure the SAVE field is set to YES.
Powerware 9315 (200 kVA ---300 kVA) Operation
164201036 Rev. D 041500
Uninterruptible Power System
DAY DT
MON 07
Statistics Graphics

Figure 16. Time Setup Screen

) appears in the upper right corner of the Time Setup
pushbutton. If you want to save the settings
04 MAY 1997
Set Time & Date
MON YR HR:MN SAVE
APR 97 15:06 YES
Setup
pushbutton. To decrease the setting
14:23:45
pushbutton on the
29