Using A Different Configuration File; Resetting To The Factory Default - ZyXEL Communications GS-2724 User Manual

Chapter 39 User and Enable Mode Commands

39.6.1 Using a Different Configuration File

You can store up to two configuration files on the Switch. Only one configuration file is used
at a time. By default the Switch uses the first configuration file (with an index number of 1).
You can set the Switch to use a different configuration file. There are two ways in which you
can set the Switch to use a different configuration file: restart the Switch (cold reboot) and
restart the system (warm reboot).
Use the
boot config
specified). The following example restarts the Switch to use the second configuration file.
sysname# boot config 2
Use the
reload config
(if specified). The following example restarts the system to use the second configuration file.
sysname# reload config 2
When you use the
file index number, the Switch saves the changes to the configuration file the
Switch is currently using.

39.6.2 Resetting to the Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
1 Enter
2 Enter
to reset the second configuration file, use the
specified index number.
The following example resets both configuration files to the factory default settings.
sysname# erase running-config
sysname# write memory
sysname# write memory 2
268
command to restart the Switch and use a different configuration file (if
command to restart the system and use a different configuration file
write memory
erase running config
to save the changes to the current configuration file. If you want
write memory
command without specifying a configuration
to reset the current running configuration.
write memory
command again with the
GS-2724 User's Guide