C
H A P T E R
Multicast VLAN Registration
This chapter shows you how to use Multicast VLAN Registration (mvr) commands.
43.1 Overview
Use the mvr commands in the configuration mode to create and configure multicast VLANs.
If you want to enable IGMP snooping see
43.2 Create Multicast VLAN
Use the following commands in the config-mvr mode to configure a multicast VLAN group.
Syntax:
mvr <vlan-id>
mvr <vlan-id> source-port <port-list>
mvr <vlan-id> receiver-port <port-list>
mvr <vlan-id> inactive
mvr <vlan-id> mode <dynamic|compatible>
mvr <vlan-id> name <name-str>
mvr <vlan-id> tagged <port-list>
mvr <vlan-id> group <name-str> start-address <ip> end-address <ip>
mvr <vlan-id> exit
where
<vlan-id>
source-port
<port-list>
receiver-port
<port-list>
name <name-str>
GS-2724 User's Guide
Section 40.2 on page
=
The VLAN ID [1 – 4094].
=
Specifies the MVR source ports which send and receive multicast
traffic.
=
Specifies the MVR receiving ports which only receive multicast
traffic.
=
A name to identify the multicast VLAN group.
43
Commands
269.
297