Chapter 42 IEEE 802.1Q Tagged VLAN Commands
The following example sets the default VID to 200 on ports 1 to 5.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# pvid 200
42.3.2 Set Acceptable Frame Type
Syntax:
frame-type <all|tagged|untagged>
where
<all|tagged|
untagged>
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# frame-type tagged
42.3.3 Enable or Disable Port GVRP
Use the
gvrp
GVRP.
The following example turns off GVRP for ports 1 to 5.
sysname (config)# interface port-channel 1-5
sysname (config-interface)# no gvrp
42.3.4 Modify Static VLAN
Use the following commands in the config-vlan mode to configure the static VLAN table.
Syntax:
vlan <vlan-id>
fixed <port-list>
forbidden <port-list>
name <name-str>
normal <port-list>
untagged <port-list>
no fixed <port-list>
no forbidden <port-list>
no untagged <port-list>
292
=
Specifies all Ethernet frames (tagged and untagged), only tagged
Ethernet frames or only untagged Ethernet frames.
command to enable GVRP on the port(s). Use the
command to disable
no gvrp
GS-2724 User's Guide