Table of Contents
Advertisement
Chapter 11 Spanning Tree Protocol
Figure 45 Multiple Rapid Spanning Tree Protocol Status
The following table describes the labels in this screen.
Table 27 Multiple Rapid Spanning Tree Protocol Status
LABEL
Configuration
Tree
Bridge
Bridge ID
Hello Time
(second)
Max Age (second)
Forwarding Delay
(second)
Cost to Bridge
Port ID
Topology
Changed Times
Time Since Last
Change
110
DESCRIPTION
Click Configuration to configure MRSTP settings. Refer to
104.
Select which STP tree configuration you want to view.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this
Switch. This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC
address. This ID is the same for Root and Our Bridge if the Switch is the root
switch.
This is the time interval (in seconds) at which the root switch transmits a
configuration message. The root bridge determines Hello Time, Max Age and
Forwarding Delay
This is the maximum time (in seconds) a switch can wait without receiving a
configuration message before attempting to reconfigure.
This is the time (in seconds) the root switch will wait before changing states (that
is, listening to learning to forwarding).
This is the path cost from the root port on this Switch to the root switch.
This is the priority and number of the port on the Switch through which this switch
must communicate with the root of the Spanning Tree.
This is the number of times the spanning tree has been reconfigured.
This is the time since the spanning tree was last reconfigured.
Section 11.3 on page
GS-2724 User's Guide
Advertisement
Table of Contents
Troubleshooting
