ZyXEL Communications GS-2724 User Manual page 243

Table 90 Command Summary: Configuration Mode (continued)
COMMAND
classifier <name> <[packet-
format
<802.3untag|802.3t
ag| EtherIIuntag|
EtherIItag>]
[priority <0-7>]
[vlan <vlan-
id>][ethernet-type
<ether-num|ip|ipx|
arp|rarp|
appletalk|decnet|
sna|netbios|dlc>]
[source-mac <src-
mac-addr>]
[source-port
<port-num>]
[destination-mac
<dest-mac-addr>]
[dscp <0-63> ]
[ip-protocol
<protocol-
num|tcp|udp|icmp|e
gp|rsvp|igmp|
igp|pim|ipsec>
[establish-only]]
[source-ip <src-
ip-addr> [mask-
bits <mask-bits>]]
[source-socket
<socket-num>]
[destination-ip
<dest-ip-addr>
[mask-bits <mask-
bits>]]
[destination-
socket <socket-
num>] [inactive]>
help
cluster <vlan-id>
member <mac-
address> password
<password-str>
name <cluster
name>
rcommand <mac-
address>
default- <in-band|out-of-
management band>
dhcp relay
GS-2724 User's Guide
Chapter 38 Introducing Commands
DESCRIPTION
Configures a classifier. A
classifier groups traffic into data
flows according to specific
criteria such as the source
address, destination address,
source port number, destination
port number or incoming port
number.
Displays help information for this
command.
Enables clustering in the
specified VLAN group.
Sets the cluster member.
Sets a descriptive name for the
cluster.
Logs into the CLI of the specified
cluster member.
Specifies through which traffic
flow the Switch is to send
packets.
Enables DHCP relay.
PRIVILEG
E
13
13
13
13
13
13
13
13
243