Test Content Sharing - Polycom Pano Administrator's Manual

9. Connect the other end of the HDMI cable to an output port on the splitter
The Pano system starts presenting on the Polycom video system once the systems and monitors
are connected. You must continue with the following steps to pair the systems and complete the
setup process.
10. In the system web interface, go to General Settings > Pairing.
11. Enter the IP Address, Admin User Name, and Admin User Password that are associated with
the Polycom video system. (If no password is set, leave the password field blank.)
12. Select Connect, then Pair.
The Pair button displays only when the connection in the previous step is successful.
13. Test that content sharing functions properly.
Related Links

Test Content Sharing

on page 74
Test Content Sharing
You can perform a test to confirm that content sent from a Pano system is displaying on a Polycom video
system and vice versa. This is helpful when you are pairing systems from a remote location.
Procedure
1. Open a browser and enter the system IP address using the format https://10.11.12.13.
Polycom, Inc.
Integrating with a Polycom Video System
74