Polycom Pano Administrator's Manual page 68

▪ Annotations made to far content can be seen by all participants.
▪ Users cannot directly connect their device to the Pano system using HDMI.
▪ To share content during a meeting, you must first place a call on the Polycom video system and
then start content.
▪ You need three HDMI cables and a 4K HDMI splitter for this setup.
Polycom has tested and recommends an HDMI splitter by CSRET with the following specifications:
▪ 1x2 HDMI Splitter Amplifier version 2.0
▪ Certified for 4Kx2K (60Hz) and 3D 1080p
▪ Supports 1 in 2 out signal distribution
You can use a different 4K splitter. If you do, make sure the specifications are comparable to those of the
CSRET product.
The following diagram illustrates how the components for this setup are connected:
HDMI Splitter with Two Monitors Setup
Begin the HDMI Splitter Setup
There are some initial steps you must complete that are specific to connecting your Pano system and
Polycom video system with an HDMI splitter.
Procedure
1. Make sure your Pano system is running the latest software.
2. Set the HDMI splitter to Scaler.
3. Connect one end of an HDMI cable to the splitter.
Polycom, Inc.
Integrating with a Polycom Video System
66