Network Settings
Topics:
▪
LAN Status Lights
▪
Configure IP Address Settings
▪
Configure DNS Settings
▪
Configure LAN Options
Once you have connected the Pano device to the LAN, you can begin configuring its network settings.
Note: Not all network types are available in every country.
Related Links
Access the System Web Interface
LAN Status Lights
The LAN connector on the Pano device has two lights to indicate connection status and traffic.
Indicator Light
Both lights off
Green and yellow lights on
Green light on and blinking yellow light
Configure IP Address Settings
You can configure IPv4 and IPv6 settings for the Pano system.
Procedure
1. In the system web interface, go to Network > IP Addresses.
2. Select one of the following options to specify how the Pano system gets its IP address:
▪
Obtain IP address automatically
▪
Enter IP address manually
3. Configure the following IPv4 settings as needed:
Polycom, Inc.
on page 9
Connection Status
No 10/100/1000 Base-T connection and no network
traffic
10/100/1000 Base-T connection
10/100/1000 Base-T connection with network traffic
23