Power Off The Device; Managing The System; Access The System Web Interface - Polycom Pano Administrator's Manual

Wireless presentation system

Hide thumbs Also See for Pano:

Table of Contents

Note: You might experience a low signal strength when connecting the device with a LAN cable

longer than 30 m (100 ft). Polycom recommends that you use an externally powered

Ethernet hub or PoE switch to limit the LAN cable length to shorter than 30 m (100 ft).

4. Connect the power source.

The device is considered on.

Power Off the Device

Powering off your Pano device depends on how you have it connected.

Procedure

1. Choose one of the following options to power off your device.

▪

Disconnect the power adapter.

▪

Disconnect the LAN cable if your device is using PoE+.

If your setup includes both connections, you must disconnect both cables.

After you run the setup wizard, you can configure, manage, and monitor your Pano device using its web

interface.

Using a supported browser with cookies enabled, you can access the Pano system web interface.

Note: A message displays notifying you when attempting to access the system web interface using a

browser with cookies disabled. This message does not appear with Microsoft Edge browsers.

Procedure

1. Open a browser and enter the system IP address using the format https://10.11.12.13.

Note: The HTTPS protocol ensures that login information is transmitted using an encrypted

channel, including usernames and passwords for communicating with third-party systems

on your network. Using HTTPS severely limits the ability of anyone on the network to

discover these credentials. For this reason, attempts to use the system web interface via

HTTP are redirected to the HTTPS interface.

2. Enter your administrator credentials.

The default Admin ID is admin, and the default admin password is the last six digits of the Pano

device serial number. You can find the serial number on a sticker on the back of the device, on the

shipping container, or on the Dashboard screen of the system web interface.

3. Select Login.