Polycom Pano Administrator's Manual page 75

5. Connect one end of an HDMI cable to HDMI 1 on the splitter.
6. Connect the other end of the HDMI cable to the HDMI Input port on the Pano system monitor.
7. Configure your Pano system monitor settings:
a. Open a browser and enter the IP address of the Pano system.
b. Go to General Settings > Monitor.
c. Select Automatic for the Configure Monitor option.
Note: If you instead choose to manually configure your monitor, make sure it supports
your selected resolution. An unsupported resolution can cause display issues.
Your changes automatically save and the monitor adjusts to the configured resolution.
8. Connect one end of an HDMI cable to the Polycom video system HDMI Input port (see images
below for port location). (For RealPresence Group 700 systems, you must connect the HDMI cable
to Input port 3.)
Polycom, Inc.
Integrating with a Polycom Video System
73