Platform Rotator - Genie Z-45 Service And Repair Manual

Service and Repair Manual
Platform Components
3 While still holding the function enable toggle
switch, simultaneously activate the primary
boom down and platform level down toggle
switches until the primary boom is fully
lowered.
The platform should be facing in a down
position. As shown.
Z45/25
Z45/25J
18 Z®-45/25 Bi-Energy • Z®-45/25J Bi-Energy
2-2

Platform Rotator

How to Bleed the Platform
Rotator
Note: This procedure will require two people. Do
not start the engine. Use auxiliary power for this
procedure.
1 Move the function enable toggle switch to
either side and activate the platform rotate
toggle switch to the right then the left through
two platform rotation cycles, then hold the
switch to the right position until the platform is
fully rotated to the right.
2 Place a suitable container underneath the
platform rotator.
3 Open the top bleed screw on the rotator, but
do not remove it.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
4 Move the function enable toggle switch to
either side and hold the platform rotate toggle
switch to the left position until the platform is
fully rotated to the left. Continue holding the
toggle switch until air stops coming out of the
bleed screw. Close the bleed screw.
Crushing hazard. Keep clear of
the platform during rotation.
September 2016
Part No. 1268546GT