How To Install The Engine Drive Pulley - Genie Z-45 Service And Repair Manual

September 2016
7 Carefully tighten each bolt evenly until the
engine drive pulley slides off the shaft.
Component damage hazard.
The engine drive pulley and/or
shaft can be damaged if the bolts
are not tightened evenly.
8 Loosen the set screw on the pulley bushing,
then slide the pulley bushing off of the engine
shaft.
1 gap
2 shaft
3 set screw
4 engine drive pulley
5 engine drive pulley bolt
6 shaft bushing
7 woodruff key
Part No. 1268546GT Z®-45/25 Bi-Energy • Z®-45/25J Bi-Energy
How to Ins tall the Engi ne Drive Pull ey
How to Install the Engine Drive
Pulley
Note: The generator pulley must already be
installed before performing this procedure. Refer to
Repair Procedure, How to Install the Generator
Pulley.
1 Align the woodruff key on the engine shaft with
the slot in the pulley bushing and slide the
pulley bushing onto the engine shaft. Do not
tighten the set screw.
2 Align the flywheel side of the pulley bushing on
the engine shaft with the outer face of the
generator pulley using a straightedge.
1 pulley shaft
2 pulley bushing
3 engine flywheel
4 straightedge
5 generator pulley
6 generator
Service and Repair Manual
Engines
41