Fault Code Charts - Genie Z-45 Service And Repair Manual

Service and Repair Manual
Fault Codes
Faul t Code C harts
Fault Code Chart
Fault Code Programmer
Diagnostic Display
Fault code LED COMMUNICATION
is off or is on, but ERROR
not blinking
1
12 HW FAILSAFE 1-2-3
13 M- SHORTED
FIELD OPEN
ARM SENSOR
FLD SENSOR
62
Condition
Machine will not drive.
Normal operation.
Machine will not drive.
Machine will not drive.
Machine will not drive.
Machine will not drive.
Machine will not drive.
Z®-45/25 Bi-Energy • Z®-45/25J Bi-Energy
Possible Causes Solution
The key switch or Push in the ground
Emergency Stop control red Emergency
button(s) was cycled Stop button to the off
on and off faster than 5 position and wait for 5
seconds OR controller seconds. Pull out the
sensed an internal ground control red
error during start up. Emergency Stop
button to the on
position. If problem
persists, replace the
motor controller.
The motor controller Replace the motor
failed self test. controller.
The motor controller Test the motor
has a internal short controller. See Repair
between M- and B- Section.
terminals.
Motor wiring is loose Check for loose or
OR motor is defective open connections at
OR motor controller the drive motors and
has an internal short. motor controller OR
replace the defective
drive motor OR test the
motor controller. See
Repair Section.
Defective motor Replace the motor
controller. controller.
Defective motor Replace the motor
controller. controller.
Part No. 1268546GT
September 2016