September 2016
9
Use a soft metal drift to drive the rod-end pivot
pin out.
Crushing hazard. The platform
could fall when the slave cylinder
rod-end pivot pin is removed if
not properly supported.
Component damage hazard.
The slave cylinder rod may
become damaged if it is allowed
to fall if not properly supported
by the lifting device.
10 Use a soft metal drift and drive the barrel-end
pin out.
11 Carefully pull the cylinder out of the primary
boom.
Part No. 1268546GT
Z®-45/25 Bi-Energy • Z®-45/25J Bi-Energy
Platform Components
How to Bleed the Sl av e Cylinder
How to Bleed the Slave Cylinder
Note: This procedure will have to be preformed
outside.
1
Z45/25J: Raise the jib to a horizontal postion
and raise the secondary boom 3 feet.
Z45/25: Raise the secondary boom 4 feet.
2
Move the function enable toggle switch to
either side. Simultaneously activate and hold
the primary boom up and platform level up
toggle switches until the primary boom is fully
raised.
The platform should be facing in an upward
position. As shown.
Z45/25
Service and Repair Manual
Z45/25J
17