Jib Boom Lift Cylinder - Genie Z-45 Service And Repair Manual

September 2016
16 Use a soft metal drift to remove the pin and let
the cylinder hang down.
Crushing hazard. The jib boom
could fall when the barrel-end
pivot pin is removed if not
properly supported by the
overhead crane.
17 Remove the pin retaining fastener from the jib
boom pivot pin. Use a soft metal drift to
remove the pin, then remove the jib boom from
the bellcrank.
Crushing hazard. The jib boom
may become unbalanced and fall
when it is removed from the
machine if it is not properly
supported by the overhead
crane.
18 Attach a lifting strap from an overhead crane
to the lug on the rod end of the jib boom lift
cylinder.
19 Use a soft metal drift to remove the jib boom
lift cylinder rod-end pivot pin, then remove the
jib boom lift cylinder from the bellcrank.
Crushing hazard. The jib boom
lift cylinder may become
unbalanced and fall when it is
removed from the machine if it is
not properly supported by the
overhead crane.
Part No. 1268546GT Z®-45/25 Bi-Energy • Z®-45/25J Bi-Energy
Jib Boom Components
3-2

Jib Boom Lift Cylinder

How to Remove the Jib Boom Lift
Cylinder
Note: Perform this procedure with the boom in the
stowed position.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Raise the jib boom slightly and place blocks
under the platform mounting weldment. Then
lower the jib boom until the platform is resting
on the blocks just enough to support the
platform.
Note: Do not rest the entire weight of the boom on
the blocks.
2 Tag, disconnect and plug the jib boom lift
cylinder hydraulic hoses. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
3 Remove the pin retaining fasteners from the
jib boom lift cylinder rod-end pivot pin. Do not
remove the pin.
Service and Repair Manual
21